Electrical System Inspections
A home Inspector is primarily responsible for visually checking the electrical system while doing a home inspection. The home inspector will certainly have a very good working understanding of the electrical system of a home, but they are not really required to carry out a code inspection for the house. Home safety is always the number one thing any home inspector will red flag while performing a home inspection. There are specific items that the home inspector examines through the inspection that is to be written up within the home inspection report that may end up in negotiations and will not be fixed.
All Home Inspectors will likely recommend the repairs be made before the house deal closures, however it often doesnt occur like this. As a home inspector I strongly recommend any kind of safety issues to be evaluated by a registered electrician. There are actually guidelines as well as standards set up to help shelter the home purchaser and the Home Inspector.
Very clear problems that will be red flagged;
o Exposed as well as unprotected electrical wires anywhere within the home; These are generally present in crawl spaces, attics and even basements and garages
o Outlets with an open or missing ground
o GFCI (ground fault circuit interrupter) that is not installed in the right areas; GFCI protected outlets are generally recommended in the kitchens following the counter tops, all bathroom plugs, garage area outlets as well as outlets on the outside of your home.
o GFCI outputs that are not working correctly is going to be written up and it should get replaced or repaired
o Solid aluminum branch electric wires shall be reported on
o Open junction boxes as well any exposed wire splices
o Any unsafe condition will be flagged as a basic safety problem
o Any unsupported wires within the crawl spaces and attics
o Problems such as; handyman wiring, incorrect use having to do with extension cords as well as any unsafe conditions
Items that really needs to be reported on as well as written in your property Inspection Report.
Check the amperage of your home and report on it:
o Check and report on the electric service entry wiring of the lodging as well as their condition
o The inspector will ideally examine a representative quantity of the electrical fixtures outside and inside of the property
o The electric panel and additionally the sub-panels needs to be checked out and reported on when it can be performed safely
o The type of electrical wiring really needs to be reported on, in the event that any existing defects are existing your home inspector will report on them all and then suggest they be evaluated by a certified electrical contractor
o If smoke detectors exist and if they are certainly working properly
o The condition and kind of grounding of the electric utility system
o The location of the home's primary electric service disconnect for the electric system
o Any risky problem which limits any home inspector with accomplishing the inspection needs to be noted within the home inspection report
Electrical issues that are usually not required to be examined and documented on:
o Voltage or impedance and calculate the amperage
o Remote control accessories in the house
o Low voltage electrical circuitry is not required to be checked out and reported on
o Any electric powered system existing that is not part of the main power source for the home
o The home inspector is definitely not recommended to look at anything that could be unsafe